Policer - Juniper JUNOS OS 10.3 - SOFTWARE Manual

policer

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
policer policer-name {
filter-specific;
if-exceeding {
bandwidth-limit bps;
bandwidth-percent percent
burst-size-limit bytes;
}
then {
policer-action;
}
}
[edit firewall]
[edit logical-systems logical-system-name firewall]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 9.0 for EX Series switches.
Logical systems support introduced in Junos OS Release 9.3.
Configure policer rate limits and actions. To activate a policer, you must include the
policer action modifier in the
you configure includes an implicit counter. To ensure term-specific packet counts, you
configure a policer for each term in the filter that requires policing.
—Name that identifies the policer. The name can contain letters, numbers,
policer-name
hyphens (-), and can be up to 64 characters long.
The remaining statements are explained separately.
firewall—To view this statement in the configuration.
firewall-control—To add this statement to the configuration.
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on EX Series
Switches on page 3039
Example: Configuring CoS on EX Series Switches on page 3173
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 3073
Configuring MPLS on Provider Edge Switches Using Circuit Cross-Connect (CLI
Procedure) on page 3405
Configuring MPLS on Provider Edge Switches Using IP Over MPLS (CLI Procedure) on
page 3401
Configuring Firewall Filters (CLI Procedure) on page 3063
Configuring Firewall Filters (J-Web Procedure) on page 3069
Understanding the Use of Policers in Firewall Filters on page 3036
Single-Rate Two-Color Policer Overview
Chapter 105: Configuration Statements for Firewall Filters
then statement in a firewall filter term. Each policer that
3111