Port-Error-Disable - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos

port-error-disable

Syntax
Hierarchy Level
Release Information
Description
Default
Required Privilege
Level
Related
Documentation
2968
®
OS for EX Series Ethernet Switches, Release 10.3
port-error-disable {
disable-timeout timeout ;
}
[edit ethernet-switching-options]
Statement introduced in Junos OS Release 9.6 for EX Series switches.
Disable rather than block an interface when enforcing MAC limiting, MAC move limiting,
and rate-limiting configuration options for shutting down the interface; and allow the
interface to recovery automatically from the error condition after a specified period of
time:
NOTE: The port-error-disable
error conditions. It impacts only error conditions that are detected after
port-error-disable
error condition and restore the interface to service, use the clear
ethernet-switching port-error command.
If you have enabled mac-limit with the
the switch disables (rather than shuts down) the interface when the MAC address limit
is reached.
If you have enabled mac-move-limit with the
port-error-disable , the switch disables (rather than shuts down) the interface when
the maximum number of moves to a new interface is reached.
If you have enabled storm-control with the
, the switch disables (rather than shuts down) the interface when
port-error-disable
broadcast traffic and unknown unicast traffic exceeds the specified levels.
Not enabled.
routing—To view this statement in the configuration.
routing–control—To add this statement to the configuration.
Configuring Autorecovery From the Disabled State on Secure or Storm Control Interfaces
(CLI Procedure) on page 2796
Configuring Port Security (CLI Procedure) on page 2906
Example: Configuring Storm Control to Prevent Network Outages on EX Series Switches
on page 2793
configuration does not apply to pre-existing
has been enabled and committed. To clear a pre-existing
shutdown option and enable
shutdown
action-shutdown
Copyright © 2010, Juniper Networks, Inc.
port-error-disable
option and you enable
option and you enable
,