Juniper JUNOS OS 10.3 - SOFTWARE Manual page 2676

Complete Software Guide for Junos
Verification
Purpose
Action
Meaning
Related
Documentation
Example: Setting Up VoIP with 802.1X and LLDP-MED on an EX Series Switch
2580
®
OS for EX Series Ethernet Switches, Release 10.3
Verify that the filter has been applied to the end devices:
Verifying That the Filter Has Been Applied to the Supplicants on page 2580
Verifying That the Filter Has Been Applied to the Supplicants
After the end devices are authenticated, verify that the filter configured on the switch
and added to each end device's user profile on the RADIUS server has been applied:
Display information about firewall filter
user@switch> show firewall filter filter1
Filter: filter1
Counters:
Name
counter1
counter2
The output of the command
Packets from Supplicant 1 are counted using
are counted using
counter2
The filter has been applied to both end devices.
Example: Setting Up 802.1X for Single Supplicant or Multiple Supplicant Configurations
on an EX Series Switch on page 2568
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on EX Series
Switches on page 3039
Configuring 802.1X RADIUS Accounting (CLI Procedure) on page 2617
Understanding Authentication on EX Series Switches on page 2526
Understanding 802.1X and VSAs on EX Series Switches on page 2544
You can configure voice over IP (VoIP) on an EX Series switch to support IP telephones.
The Link Layer Discovery Protocol–Media Endpoint Discovery (LLDP-MED) protocol
forwards VoIP parameters from the switch to the phone. You also configure 802.1X
authentication to allow the telephone access to the LAN. Authentication is done through
a backend RADIUS server.
filter1 :
show firewall filter filter1
counter1
. The output displays packets incrementing for both counters.
Bytes Packets
128
64
displays counter1 and counter2
, and packets from Supplicant 2
Copyright © 2010, Juniper Networks, Inc.
2
1
.