Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3177

Table 391: Terms Configuration Parameters (continued)
Field Function
Load Balance Per Specifies that all next-hop addresses in the forwarding table
Packet must be installed and have the forwarding table perform
per-packet load balancing. This policy action allows you to
optimize VPLS traffic flows across multiple paths.
Tag Specifies the tag value. The tag action sets the 32-bit tag field
in OSPF external link-state advertisement (LSA) packets.
Metric Changes the metric (MED) value by the specified negative or
positive offset. This action is useful only in an external BGP
(EBGP) export policy.
Route Specifies whether the route is external.
Preference Specifies the preference value.
Local Preference Specifies the BGP local preference attribute.
Class of Service Specifies and applies the class-of-service parameters to routes
installed into the routing table.
Source class
The value entered here maintains the packet counts for a
route passing through your network, based on the source
address.
Destination class
The value entered here maintains packet counts for a route
passing through your network, based on the destination
address in the packet.
Forwarding class
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Configuring BGP Sessions (J-Web Procedure) on page 1677
Configuring an OSPF Network (J-Web Procedure) on page 1681
Configuring a RIP Network (J-Web Procedure) on page 1685
Configuring Static Routing (J-Web Procedure) on page 1690
Layer 3 Protocols Supported on EX Series Switches on page 14
Chapter 102: Configuring Firewall Filters
Your Action
Select the check box to enable the option.
Select the action and type a value.
Select the action and type a value.
Select the check box to enable
External
the option, and select the OSPF type.
Select the preference action and type a
value.
Select the action and type a value.
Type the source class.
Type the destination class.
Type the forwarding class.
3081