Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3125

Table 382: Action Modifiers for Firewall Filters (continued)
Action Modifier
count counter-name
forwarding-class class
interface interface-name
log
loss-priority (high | low)
policer policer-name
syslog
Copyright © 2010, Juniper Networks, Inc.
Description
Count the number of packets that pass this filter, term,
or policer.
Classify the packet in one of the following forwarding
classes:
assured-forwarding
best-effort
expedited-forwarding
network-control
Forward the traffic to the specified interface bypassing
the switching lookup.
Log the packet's header information in the Routing
Engine. To view this information, issue the
log command in the CLI.
NOTE: is not a supported action modifier for IPv6
log
traffic.
Set the packet loss priority (PLP).
Apply rate limits to the traffic.
You can specify a policer for ingress port, VLAN, and
router firewall filters only.
Log an alert for this packet. You can specify that the
log be sent to a server for storage and analysis.
NOTE: is not a supported action modifier for
syslog
IPv6 traffic.
NOTE: On EX Series switches,
the only actions supported for firewall filters applied on loopback interfaces.
Chapter 100: Firewall Filters—Overview
Supported Platforms and Direction
EX2200—ingress only
NOTE: On EX2200 switches,
supported for VLAN firewall filters only.
EX3200 and EX4200—ingress and
egress
EX4500—ingress only
EX8200—ingress only
EX2200—ingress and egress
EX3200 and EX4200—ingress and
egress
EX8200—ingress and egress
EX2200—not supported
EX3200 and EX4200—ingress only
EX8200—ingress only
EX2200—ingress only
show firewall
EX3200 and EX4200—ingress only
EX8200—ingress only
EX2200—ingress and egress
EX3200 and EX4200—ingress and
egress
EX8200—ingress and egress
EX2200—ingress only
EX3200 and EX4200—ingress only
EX8200—ingress only
EX2200—ingress only
EX3200 and EX4200—ingress only
EX8200—ingress only
and in the ingress direction, are
accept discard
is
count
3029