Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3176

Complete Software Guide for Junos
Table 391: Terms Configuration Parameters (continued)
Field Function
Interface Specifies a name or IP address of one or more routing device
interfaces. Do not use this qualifier with protocols that are not
interface-specific, such as internal BGP (IBGP).
Protocol Specifies the name of the protocol from which the route was
learned or to which the route is being advertised.
Action tab
Action Specifies the action to take if the conditions match.
Default Action Specifies that any action that is intrinsic to the protocol is
overridden. This action is also nonterminating, so that various
policy terms can be evaluated before the policy is terminated.
Next Specifies the default control action if a match occurs, and there
are no further terms in the current routing policy.
Priority Specifies a priority for prefixes included in an OSPF import
policy. Prefixes learned through OSPF are installed in the
routing table based on the priority assigned to the prefixes.
BGP Origin Specifies the BGP origin attribute.
AS Path Prepend Affixes an AS number at the beginning of the AS path. The AS
numbers are added after the local AS number has been added
to the path. This action adds an AS number to AS sequences
only, not to AS sets. If the existing AS path begins with a
confederation sequence or set, the affixed AS number is placed
within a confederation sequence. Otherwise, the affixed AS
number is placed with a nonconfederation sequence.
AS Path Expand Extracts the last AS number in the existing AS path and affixes
that AS number to the beginning of the AS path n times, where
n is a number from 1 through 32. The AS number is added before
the local AS number has been added to the path. This action
adds AS numbers to AS sequences only, not to AS sets. If the
existing AS path begins with a confederation sequence or set,
the affixed AS numbers are placed within a confederation
sequence. Otherwise, the affixed AS numbers are placed within
a nonconfederation sequence. This option is typically used in
non-IBGP export policies.
3080
®
OS for EX Series Ethernet Switches, Release 10.3
Your Action
To add an interface, select
Add >
. Select the interface from the
Interface
list.
To add an address, select
Add > Address
Select the address from the list.
To delete an interface, select it and click
.
Remove
Click and select the protocol from
Add
the list.
To delete a protocol, select it and click
.
Remove
Select a value from the list.
Select a value from the list.
Select a value from the list.
Select a value from the list.
Select a value from the list.
Enter a value.
Select the type and type a value.
Copyright © 2010, Juniper Networks, Inc.
.