Show Pim Rps - Juniper JUNOS OS 10.3 - SOFTWARE Manual

show pim rps

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Copyright © 2010, Juniper Networks, Inc.
Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
show pim rps
<brief | detail | extensive>
<group-address>
<inet | inet6>
<instance instance-name>
<logical-system (all | logical-system-name)>
show pim rps
<brief | detail | extensive>
<group-address>
<inet | inet6>
<instance instance-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
and options introduced in Junos OS Release 10.0 for EX Series switches.
inet6 instance
Display information about Protocol Independent Multicast (PIM) rendezvous points
(RPs).
—Display standard information about PIM RPs for all groups and family addresses
none
for all routing instances.
brief | detail | extensive —(Optional) Display the specified level of output.
—(Optional) Display the RPs for a particular group. If you specify a group
group-address
address, the output lists the routing device that is the RP for that group.
inet | inet6 —(Optional) Display information for IPv4 or IPv6 family addresses, respectively.
—(Optional) Display information about RPs for a specific
instance instance-name
PIM-enabled routing instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show pim rps on page 2507
show pim rps brief on page 2507
show pim rps instance on page 2507
show pim rps extensive on page 2508
show pim rps extensive (PIM Anycast RP in Use) on page 2508
Table 329 on page 2506 describes the output fields for the
fields are listed in the approximate order in which they appear.
—(Optional) Perform this operation on all logical
show pim rps
command. Output
2505