Show Pim Interfaces; Table 326: Show Pim Interfaces Output Fields - Juniper JUNOS OS 10.3 - SOFTWARE Manual

show pim interfaces

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields

Table 326: show pim interfaces Output Fields

Field Name Field Description
Instance Name of the routing instance.
Name Interface name.
State State of the interface. The state also is displayed in the
Copyright © 2010, Juniper Networks, Inc.
Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
show pim interfaces
<inet | inet6>
<instance instance-name>
<logical-system (all | logical-system-name)>
show pim interfaces
<inet | inet6>
<instance instance-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
and options introduced in Junos OS Release 10.0 for EX Series switches.
inet6 instance
Display information about the interfaces on which Protocol Independent Multicast (PIM)
is configured.
none —Display interface information for all family addresses for all routing instances.
—(Optional) Display interface information for IPv4 or IPv6 family addresses,
inet | inet6
respectively.
—(Optional) Display information about interfaces for a specific
instance instance-name
PIM-enabled routing instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show pim interfaces on page 2494
show pim interfaces inet on page 2495
show pim interfaces inet6 on page 2495
Table 326 on page 2493 describes the output fields for the
Output fields are listed in the approximate order in which they appear.
—(Optional) Perform this operation on all logical
show pim interfaces
show interfaces command.
command.
2493