A Specific Interface - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos
Customizing the Ethernet Switching Table Display to View Information for a Specific Interface
Purpose
Action
2940
®
OS for EX Series Ethernet Switches, Release 10.3
For the action results—The sixth MAC address exceeded the MAC limit. No MAC
log
addresses were blocked.
For the shutdown action results—The fourth MAC address exceeded the MAC limit. Only
three MAC addresses have been learned on
down.
For more information about interfaces that have been shut down, use the
ethernet-switching interfaces
user@switch> show ethernet-switching interfaces
Interface State VLAN members
bme0.32770 down mgmt
ge-1/0/0.0 down v1
ge-1/0/1.0 up v1
ge-1/0/2.0 up v1
me0.0 up mgmt
NOTE: You can configure the switch to recover automatically from this type
of error condition by specifying the
value. The switch automatically restores the disabled interface to
timeout
service when the disable timeout expires. The
does not apply to pre-existing error conditions. It impacts only error conditions
that are detected after
To clear a pre-existing error condition and restore the interface to service,
use the clear ethernet-switching port-error
You can use the
show ethernet-switching table
specific interface.
For example, to display the MAC addresses that have been learned on
type:
user@switch> show ethernet-switching table interface ge-0/0/2.0
Ethernet-switching table: 1 unicast entries
VLAN MAC address
v1 *
. The interface
ge-0/0/2
command.
Tag Tagging
untagged unblocked
untagged MAC limit exceeded
untagged unblocked
untagged unblocked
untagged unblocked
port-error-disable
port-error-disable
has been enabled and committed.
port-error-disable
command.
command to view information for a
Type Age Interfaces
Flood
Copyright © 2010, Juniper Networks, Inc.
is shut
ge-0/0/1
show
Blocking
statement with a
disable
configuration
ge-0/0/2 interface,
- All-members