Mtrace To-Gateway - Juniper JUNOS OS 10.3 - SOFTWARE Manual

mtrace to-gateway

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
mtrace to-gateway gateway gateway
<brief | detail>
<extra-hops extra-hops>
<group group>
<interface interface-name>
<interval interval>
<loop>
<max-hops max-hops>
<max-queries max-queries>
<multicast-response | unicast-response>
<no-resolve>
<no-router-alert>
<response response>
<routing-instance routing-instance-name>
<ttl ttl>
<unicast-response>
<wait-time wait-time>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Display trace information about a multicast path from this router or switch to a gateway
router or switch.
—Send the trace query to a gateway multicast address.
gateway gateway
brief | detail —(Optional) Display the specified level of output.
—(Optional) Number of hops to take after reaching a nonresponsive
extra-hops extra-hops
router or switch. You can specify a number between
—(Optional) Group address for which to trace the path. The default group
group group
address is .
0.0.0.0
—(Optional) Source address for sending the trace query.
interface interface-name
—(Optional) Number of seconds to wait before gathering statistics again.
interval interval
The default value is 10
—(Optional) Loop indefinitely, displaying rate and loss statistics.
loop
max-hops max-hops —(Optional) Maximum hops to trace toward the source. You can
specify a number between
max-queries max-queries —(Optional) Maximum number of query attempts for any hop.
You can specify a number between
—(Optional) Always request the response using multicast.
multicast-response
—(Optional) Do not attempt to display addresses symbolically.
no-resolve
.
and .. The default value is
0 255
and .. The default value is
0 255
0 and 255 .
.
32
.
3
2445