Trip Counters (S6.8.2); Resetting The Trip Counters; Software (S6.8.3) - Danfoss VACON NXS Series Operating Manual

Operating Guide | VACON® NXS/NXP Air-cooled
Page Counter
C6.8.1.2. Power On day counter
C6.8.1.3 Power On hour counter

8.7.9.3 Trip Counters (S6.8.2)

The Trip counters page (S6.8.2) has information on resettable counters, that is, counters, for which the value can be set back to 0. The
trip counters count only when the motor is in RUN state.
Table 16: Trip Counters
Page Counter
T6.8.2.1 MWh counter
T6.8.2.3 Operation day counter
T6.8.2.4 Operation hour counter

8.7.9.4 Resetting the Trip Counters

Context:
Use these instructions to reset the trip counters.
Procedure
1. In the System info submenu, find the Trip counters page (6.8.2) with the Browser buttons.
2. To go to the Clear MWh counter page (6.8.2.2, Clr MWh cntr) or to the Clear Operation time counter page (6.8.2.5, Clr Optime cntr),
use the Menu button Right.
3. To go to the edit mode, push the Menu button Right.
4. To select Reset, push Browser buttons Up and Down.
5. To accept the selection, push the [enter] button.
6. The display shows again Not reset.

8.7.9.5 Software (S6.8.3)

The Software information page includes information on the AC drive software.
Page
6.8.3.1
6.8.3.2
6.8.3.3
6.8.3.4
138 | Danfoss A/S © 2020.02
Example
Value on display is 1.013. The drive has operated for 1 year and 13 days.
Value on display is 7:05:16. The drive has operated for 7 hours 5 minutes and 16 s.
Example
–
Value on display is 1.013. The drive has operated for 1 year and 13 days.
Value on display is 7:05:16. The drive has operated for 7 hours 5 minutes and 16 s.
Content
Software package
System software version
Firmware interface
System load
Using the Control Panel
AQ275638903263en-000301 / DPD00910