ABB IRB 6600 - 175/2.55 User Manual page 363

8.0.5 LAN Settings Window
When is it
The LAN Settings window will be displayed when LAN Settings is pressed in the Network
shown?
Settings window as shown in the figure in section "Network Settings".
en0100000256
NONE
CANCEL
Node
identification
Parameter
MAC ID
Current IP
IP
(Subnet mask)
(Gateway)
Configure for 1. Press FIX IP .
fixed IP network
2. Fill in the assigned IP address for the Main Computer, and the Subnet Mask and
3. Press YES to make the new setting take effect.
Configure for 1. Press DHCP .
DHCP distributed
2. The value for IP will change to DHCP.
IP network
3. Press OK.
4. Press YES to make the new setting take effect.
3HAC 16245-1
will, after the system is rebooted, remove the IP settings.
returns to the Start window, as shown in the figure in section "Start Win-
dow", without changing any settings.
Type
Node identification
Node identification
Network setting
Network setting
Network setting
Gatway for the Network and press OK .
You will be asked to reboot the system.
You will be asked to reboot the system.
A
8 Robot controller
8.0.5 LAN Settings Window
Description
The Main Computer's ethernet address.
The Main Computer's current IP address. This row
is blank if the LAN Settings has not been defined.
Space for typing a new IP address, for the Main
Computer or the DHCP server. See Configure for
fixed IP network and Configure for DHCP distrib-
uted IP network below.
Shows the subnet mask of the network.
Only visible when configured for fixed IP.
Shows the gateway IP for the network.
Only visible when configured for fixed IP.
161