Connecting The Instrument To The Computer With A Usb Cable - Hioki MEMORY HiLOGGER LR8450 Instruction Manual

Configuring and Establishing a USB Connection

Connecting the instrument to the computer with a USB cable

This section describes how to connect the instrument to a computer with a USB cable.
Instructions
You cannot use both the Logger Utility and communication commands at the same time over
the USB connection. Allow at least 30 s to switch between the Logger Utility and communication
commands.
Find Quality Products Online at:
Do not unplug the USB cable while the instrument is sending or receiving data.
„
Doing so could damage the instrument.
Turn off the instrument and computer before connecting or disconnecting the
„
USB cable.
Failure to do so could cause the instrument to malfunction or damage it.
Ensure the instrument and computer are grounded at the same potential.
„
Connecting the USB cable while the ground potentials differ between the instrument
and computer could cause the instrument to malfunction or damage it.
GlobalTestSupply
www.
NOTICE
1
Insert the USB cable plug into the
instrument's USB cable connector,
exercising care to ensure that the plug is
oriented properly.
2
Connect the other end of the USB cable
to the computer's USB connector.
.com
sales@GlobalTestSupply.com