Configuring numerical calculations
>
1
Under
OFF
2
Under
Disable
Enable
Timed
If the
When the numerical calculation result type for the auto-save is set to [OFF], the
setting is disabled.
See "Auto save (real-time save)" (p. 1 42).
Set the format for numerical calculation results to
(When
Under
0
days
For example, if the segment time is set to 10 min., the calculation will be performed, and the calculation results
saved, every 10 min.
measurement
Find Quality Products Online at:
>
1 1
2
2
3 3
[Numerical
calculation], set the numerical calculation function to [ON].
,
ON
[Time split
calculation], select the file saving method used for the auto-save.
Performs the numerical calculation using all data acquired from the measurement start
to the measurement stop, and then saves the calculation results.
Segments the data set into those with a length of the set interval beginning from the
measurement start*, performs calculations using the segmented data sets, and saves
the calculation results by interval basis.
*: When the trigger setting is enabled, segments the data set beginning from the start
trigger point.
The first interval length will automatically be adjusted so that calculation values yielded
at regular intervals
first interval will become shorter than the
[Enable]
or
[Timed]
setting has been selected, calculation results will be saved for each time interval.
[Time split calculation]
is set to [Enable])
[Split
time], set the time interval at which to perform the calculation.
00:01
to
30
days
23:59
Segment time
Start
Stop
Reference
measurement
time
GlobalTestSupply
www.
4 4
5 5
6 6
([Split
time]) base on the
[Reference time]
[Split
[Text
(CSV)].
Calculation results will be saved at the specified intervals
based on the reference time.
The value 0 d 0 h 0 min. cannot be specified as the
segment time. The value will be automatically changed to
0 d 0 h 1 min.
7 7
are saved. (Only the
time].)
[Time split calculation]
.com
sales@GlobalTestSupply.com
Need help?
Do you have a question about the MEMORY HiLOGGER LR8450 and is the answer not in the manual?