Performing A Self-Check - Hioki MEMORY HiLOGGER LR8450 Instruction Manual

Controlling the System

Performing a self-check

This section describes how to perform a self-check.
The results will be shown on the screen. Contact your authorized Hioki distributor or reseller in the
event of an abnormal result.
>
1
Select the type of diagnostics you wish to perform in the
ENTER
The self-check window will open.
2
Follow the instructions to perform the self-check.
Key...
LCD...
ROM/RAM...
LAN...
Media...
Unit...
Find Quality Products Online at:
>
key.
Checks key recognition. Additionally, verifies that the LEDs are working properly.
The self-check will end once all keys have been checked.
You can force-quit the self-check in the event of a malfunction by pressing the
twice.
Checks the screen display.
The screen will cycle through the following colors and then return to the original screen
each time you press a key:
White → black → red → green → blue → gradation
Checks the instrument's built-in memory (ROM, RAM).
Checks if the LAN interface operates properly.
If a FAIL judgment exhibits, check cable connection and settings including the IP
address and firewall.
If such a condition cannot be corrected, please contact your authorized Hioki distributor
or reseller to have the instrument repaired.
Checks if the SD Memory Card and USB Drive can be detected.
Displays information about connected modules and checks their status.
When you press the
to confirm is selected, the LED of the wireless module concerned will blink for a few
seconds.
GlobalTestSupply
www.
1 1
[Self check]
ENTER key while [Reference]
area and press the
ESC
of the wireless module you wish
.com
sales@GlobalTestSupply.com
key