Configuring Settings - Hioki MEMORY HiLOGGER LR8450 Instruction Manual

Configuring Settings

7.1 Configuring Settings

This section describes how to configure various system functions.
>
1
Under [Start
(start back up).
When set to [ON], the instrument will automatically resume recording when the power comes back
on after being interrupted during measurement, for example due to a power outage.
OFF

ON
If triggers are being used, the instrument will enter the trigger wait state.
If measurement is resumed while in the start retention state, data that was stored in the instrument's internal
buffer memory before the power outage will be deleted.
2
Under [Auto start
instrument is turned on.
Setting the function to
When the trigger setting is enabled, the instrument will get into the trigger standby state.
OFF

ON
Find Quality Products Online at:
>
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
10 10
backup], select the operation to perform when the instrument is turned back on
Does not use the start state retention function.
Uses the start state retention function.
measurement], select the measurement operation to perform when the
[ON] can automatically start measurement on the startup of the instrument.
Disables the startup auto-measurement function.
Enables the startup auto-measurement function.
GlobalTestSupply
www. .com
sales@GlobalTestSupply.com