Configuring Input Channels
Measuring rotational speed
This section describes how to measure the pulses output by a rotary encoder, tachometer, or
similar device.
The instrument counts the number of pulses per second and calculates the rotational speed.
This section describes how to configure settings on the individual settings screen when measuring
rotational speed.
You can use the settings list screen to configure the settings. (See p. 6 9.)
External control terminals: Pulse input terminals P1 to P8
>
1
Select [Pulse], and choose a channel from
Measurement will not be performed for channels whose check boxes are not selected.
2
Select the waveform display color.
×
(OFF), 24 colors
Select
[×]
screen.
3
Set the input type to [RevSpd].
4
Under [Range], select the count base time.
The measurable range of the selected range will be displayed.
r/s
r/min
5
Under [Pulse/rev], enter the number of pulses per revolution output by the encoder or
tachometer.
1
1000
to
Find Quality Products Online at:
>
1 1
4
4
5 5
9 9
if you wish to measure the channel but not to display its waveform or numerical values on the
Counts the number of pulses per second and calculates the rotational speed. (Number
of revolutions per second)
Counts the number of pulses per module of time specified with the
setting and calculates the rotational speed.
(Number of revolutions per minute)
GlobalTestSupply
www.
2 2
3 3
[P1]
to [P8].
.com
6 6
7 7
8 8
[Smoothing]
sales@GlobalTestSupply.com
Need help?
Do you have a question about the MEMORY HiLOGGER LR8450 and is the answer not in the manual?