Auto-Setup Function - Hioki MEMORY HiLOGGER LR8450 Instruction Manual

Overwrite mode
Only when the configuration of the plug-in modules remains the same as that had been applied
when the data was saved, the file can be loaded.
Attempting to load a file with the different configuration of the plug-in modules will cause a loading
error.
View mode
When loading a file in View mode, the instrument will save the present settings in the internal buffer
memory.
The setting condition will temporarily change; however, exiting View mode will enable the previous
settings to restore.
The instrument cannot start measurement in View mode.
How to exit View mode
To exit View mode, execute any one of the following actions:
• Press the
• Press the
setting.)
• Press the
• Load the file in overwrite mode.
• Turn off the instrument. Initialize the instrument. Send the communications command.

Auto-setup function

This section describes how to automatically load the setting file on startup.
Save the
will automatically load the file.
If both the SD Memory Card and the USB Drive contain the
preferentially load the file on the SD Memory Card.
The instrument can automatically load the settings saved in the instrument's internal backup
memory.
See "Saving settings to the instrument's internal backup memory" (p. 1 55).
Find Quality Products Online at:
ENTER key while [Exit VIEW mode]
START
key. (The instrument will start measurement after restoring the previous
MONITOR key.
[STARTUP.SET]
file in the
GlobalTestSupply
www.
on the file list screen is selected.
[CONFIG] [HIOKI]
folder (under
[STARTUP.SET]
.com
Loading Data
> [LR8450]). The instrument
file, the instrument will
sales@GlobalTestSupply.com