Hioki MEMORY HiLOGGER LR8450 Instruction Manual page 310

6. Triggers
Trigger method
Trigger timing
Trigger conditions
Trigger sources
Trigger types
Interval triggers
External triggers
Trigger response time With plug-in module(s):
Trigger level
resolution
Pre-triggers
Find Quality Products Online at:
Digital comparison method
Start, stop, or start & stop
AND/OR operation performed on trigger source, interval trigger, or external trigger
When triggers are disabled, free run
Analog, pulse, logic, waveform calculations, CAN (up to 100)
Analog, pulse, Level triggers
waveform calculations,
CAN Window triggers
Logic, CAN Trigger activated when patterns of 1/0/X match (where "X"
indicates either)
Trigger activated for set recording interval after setting days/hours/minutes/seconds
Trigger activated by rising or falling edge at set level in external input signal
Rising/falling (user-selectable)
(Recording interval or data refresh interval, whichever is longer) × 2
+ 1 ms + (analog response time)*
When using the wireless modules (LR8450-01 only):
(Recording interval or data refresh interval, whichever is longer) × 2
2
+ (wireless response time)* + (analog response time)*
*1: Depending on filter settings (U8554 with a data refresh interval of 5 ms and low-pass
filter of 120 Hz).
*2: When the radio-wave state is in good condition, 1s.
Analog 0.1% f.s. (f.s. = 10 divisions)
Pulse Integration 1c, rotational speed 1/n (where n = pulse count per
rotation setting)
Set day/hours/minutes/seconds.
Can be set during real-time saving.
GlobalTestSupply
www.
Trigger activated by rising or falling edge at set level
Set by trigger level upper limit and lower limit
Trigger activated when value leaves area or when value
enters area
1
1
.com
Basic Specifications
sales@GlobalTestSupply.com