How To Configure Rip - NetComm NTC-6908 User Manual

Del eting Static Rou utes
Sele ct the "Delete Entry" text (in blue) for the
Ho ow to Conf figure RIP
RIP (Routing Information Protocol) is used for
For e example, the route fo or the router's Etherne
Ethe ernet subnet.
You will have to add the r routes appropriately
NOTE: it is poss sible that some route
To e nable RIP click on th he "Internet Settings"
Set th e Enable RIP option
Selec t the RIP version you
Click Save RIP
NTC C-6000 Series – Indus strial M2M Wireless R
36
www w.netcommwireless.c com
route as shown in the e figure above.
r advertising routes to o other routers. Thus all the routes in the r
et subnet could be ad dvertised to a Router r on the PPP interface
in the Static Routes s section – see Adding g Static
rs will ignore RIP.
menu followed by "R Routing" and then the e "RIP" menu item on
to Enable.
wish to use.
Routers
NETCOMM CALLDIRECT™ SERIES – NTC
Figure 47: Del leting a Static Route
router's routing table will be advertised to
e side so that a Route er on this network wil
Routes.
the right.
Figure 4 8: Internet Settings ‐ Routing – RIP
C-6000 Serie s
e Entry
other nearby routers s.
ll know how to route t to a device on the ro uter's
YML6908