FujiFilm DR-ID 1300 Service Manual page 94

Error
Error Name
Code
12600 Correction data load read retry
12601 System file load retry
12610 FTP transfer failed
12611 FTP setting failed
12699 File operation error
Process request from MUTL
12700
rejected
12900 Parameter error
Exposure menu error (operative
12901
method not specified)
018-234-06E
Occurrence Condition
[During bootup]
An attempt is made to read the correction data from the SSD (solid state
device) and load into the CPU board memory and the SODIMM mounted
on the SPC board, but results in a failure in reading from the SSD. The
attempt is retried.
<Reference>
You can know the file name which cannot be read on the error log.
[During bootup]
As reading of the system file fails, a retry is made to read from the backup
file.
<Reference>
You can check that recovery is made during bootup on the error log.
[During bootup/routine processing]
Transfer to the FTP (file transfer protocol) fails.
<Reference>
You can know the file name which cannot be transferred on the error log.
[During routine processing]
Occurs when the FTP connection settings (user name, password, IP
address) which are being used for the MP version upgrade etc. cannot be
set.
Occurs when there are mismatches in the versions between the MP and
MC.
[During bootup/routine processing]
An error is detected during file operation.
[During bootup]
Some processing takes place during background calibration (calibration
automatically taking place when the CU starts up).
[During M-Utility]
An attempt is made to carry out respective modes of offset calibration/
defect calibration/residual image calibration, but results in failure.
[During bootup/routine processing]
An error is detected in an item set by service personnel (wrong value
setting, inconsistency of combination, or the like)
[During exposure menu registration]
The exposure menu cannot be accepted because the operative method is
not specified.
DR-ID 1300 / DR-ID 1300PU Service Manual
Probable Cause and Remedy
- Check the SSD.
- Check the SSD.
- Make another attempt to update in version.
- Check the FTP server.
- Check the LAN cable.
If this occurs in an MC V16.5 or later usage environment
during the installation, then upgrade the MP version
(requires 00.04.05 or later). The FTP connections will be
set to the MP by this work.
This may be recorded when starting up in an MC V17.1
environment, but the occurrence of this error is not a
problem.
- Check the user operation.
- Check the selector menu of the CL.
- Check the settings in EDIT CONFIG.
MT-17
MT-17