FujiFilm DR-ID 1300 Service Manual page 549

NOTE
- Select the folder corresponding with the IMAGE READING MODE settings in
Edit Configuration.
{MU2:1.11_EDIT CONFIGURATION}
- The folders suitable for IMAGE READING MODE are stored in the folders by
the serial ID of the panel unit in the root of the machine-specific data CD-ROM.
Select the folder in the serial ID of the panel unit corresponding to the panel
number.
CD-ROM
└<Serial ID for TOP panel unit> (TOP) folder
└CORRECTH folder
└CORRECTS folder
└<Serial ID for CENTER panel unit> (CENTER) folder
└CORRECTH folder
└CORRECTS folder
└<Serial ID for BOTTOM panel unit> (BOTTOM) folder
└CORRECTH folder
└CORRECTS folder
Directory selection window
#3
#4
REFERENCE
Select the "CORRECTH" folder nomally.
However, if in the acceptance check the noise was generated in the image
whereas physical phantoms such as mesh, etc. are used to expose, select the
"CORRECTS" folder. For the procedure for changing the folder selection, refer
to "RU IMAGE FLAG window_IMAGE READING MODE" of "MU1.11_EDIT
CONFIGURATION".
{MU2:1.11_EDIT CONFIGURATION}
018-234-04E
#1
#2
1200_700190.ai
(5) Click [OK].
#1 Click: [OK]
Directory selection window
(6) Click [OK] when "Completed" appears.
#1 Click: [OK]
Completed window
(7) For the other two panel units, perform steps (4) to (6).
(8) Remove the machine-specific data CD from the CL.
(9) Left-click the MC Manager from the task tray and execute "EXIT".
Check that the MC Manager icon has disappeared from the task tray, and then start
the MC Manager from "Start menu" → "Start-up".
(10) Complete the CL and confirm that the background calibration is
performed.
REFERENCE
Defect correction data is generated according to the background calibration
during the CL termination.
DR-ID 1300 / DR-ID 1300PU Service Manual
#1
600_700094.ai
#1
600_700095.ai
IN2-72
IN2-72