FujiFilm DR-ID 1300 Service Manual page 330

l EXTRA SLEEP START TIME
Set the time in minutes units until when the extra sleep mode is started.
<Setting range>
- 2 to 999 [default: 999]
REFERENCE
- After all the SEs shift to the sleep mode and past the set time by this setting, shift to
the extra sleep mode.
- When set to "999", do not shift to the extra sleep mode.
018-234-03E
 OPE SETTING (UPRIGHT/TABLE/FREE)
OPE SETTING corresponds to Reader Type (selector) set on the DX Console.
Make the OPE SETTING and Reader Type settings coincide with each other.
EDIT CONFIGURATION
u NOTES u
- If [FPD-U] is registered in any selector, always carry out the following operations.
- Connect the stand-type X-ray shot cable to the MP.
- Specify the destination of connection via the PC-TOOL in [OPE SETTING
(UPRIGHT)] and [PORT SETTING (UPRIGHT)].
- Specify whether the exposure image is to be rotated 180 degrees via the PC-
TOOL in [UPRIGHT 180 REVERSE].
- If [FPD-T] is registered in any selector, always carry out the following operations.
- Connect the bed-type X-ray shot cable to the MP.
- Specify the destination of connection via the PC-TOOL in [OPE SETTING
(TABLE)] and [PORT SETTING (TABLE)].
- Specify the direction of the patient's head via the PC-TOOL in [TABLE
DIRECTION HEAD].
- If [FPD-C] is registered in any selector, always carry out the following operations.
- Connect the free X-ray shot cable to the MP.
- Specify the destination of connection via the PC-TOOL in [OPE SETTING
(FREE)] and [PORT SETTING (FREE)].
DR-ID 1300 / DR-ID 1300PU Service Manual
Selector (DX Console)
Corresponding
MU2-65
1200_400041E.ai
MU2-65