REFERENCE
- There is no problem if the list of correct data is displayed as shown below.
In addition, the display of the "Mode3OffsetDataAvailable" -
"Mode6OffsetDataAvailable" and "Mode3InitialCalibrationCompleted" depends on
the setting for the LONG TIME ACCUM MODE. Therefore, there is no problem if "NG"
is displayed.
GainDataAvailable
SensitivityDataAvailable
LagDataAvailable
Mode0OffsetDataAvailable
Mode1OffsetDataAvailable
Mode2OffsetDataAvailable
Mode3OffsetDataAvailable
Mode4OffsetDataAvailable
Mode5OffsetDataAvailable
Mode6OffsetDataAvailable
DotDefectDataAvailable
LineDefectDataAvailable
InitialCalibrationCompleted
Mode3InitialCalibrationCompleted
- If the initialization calibration has not been completed, "false" is displayed.
018-234-06E
:true
:true
:true
:true
:true
:true
:true
:true
:true
:true
:true
:true
:true
:true
Correct Data Status (FLASH)
Check the list of correct data stored in the FLASH of SE.
(1) Click [GET].
The list of FLASH correct data is displayed .
(2) Confirm the
correction data's (FLASH) saving conditions.
list of
DR-ID 1300 / DR-ID 1300PU Service Manual
MU1-42
(1)
(2)
1200_400079E.ai
MU1-42