FujiFilm DR-ID 1300 Service Manual page 326

<"WIRELESS SETTING" window>
u NOTE u
The DR-ID 1305SE does not have the wireless function. Set the wireless function only
for connecting the DR-ID 1201SE/1202SE/1211SE/1212SE/1213SE/1214SE.
WIRELESS SETTING window
l ESSID
Sets the network identifier of the wireless LAN for the SE.
Usually use the setting of FUJIAP01 [default].
When two or more SE's are to be installed in one installation site, make settings so
that the identifiers of the respective SE's do not overlap.
Make the same setting of the identifier on the AP.
<Options>
- FUJIAP01 to FUJIAP10, MANUAL [default: FUJIAP01]
l ESSID MANUAL (arbitrary ID setting for wireless LAN)
Sets an arbitrary ID in case that "MANUAL" has been selected at "ESSID".
When two or more SE's are to be installed in one installation site, make settings so
that the ID's of the respective SE's do not overlap. Make the same setting of the ID on
the AP.
- A single-byte text string of 32 characters or less
018-234-03E
1200_400036.ai
l CHANNEL & MODE
Selects the wireless channel to be used.
Setting a dual channel with higher communication rate is recommended for the
machine.
If the communication rate drops, overlapping channels in the site are possibly present.
Change the setting.
REFERENCE
- When multiple access points are vicinally placed, changing the channel currently used
can prevent decreasing the communication speed due to interferences.
- The Auto 20/40 MHz mode changes the band automatically between 20 and 40
MHz. The 40 MHz band can provide faster communication than the 20 MHz band,
but the channel cannot be fixed to the 40MHz band.
u NOTE u
- In accordance with the Radio Law, the W52 and W53 type channels (36, 40, 44,
48, 52, 56, 60 and 64) cannot be used outdoors. If wireless communications are to
be used outdoors, select a 5 GHz other than the aforementioned channels or a 2.4
GHz. All of the channels can be used indoors.
- When the W53 or W56 type channel is selected, if interference is detected, then
perform the following workaround operations. This is because avoiding interference
with the weather radar is required by the DFS (Dynamic Frequency Selection).
- In order to detect radar waves about one minute before starting the
communication with each channel, the wireless communication cannot be
performed during the detection.
- If radar waves are detected during the the wireless communication, the
wireless communication may be interrupted or the bandwidth may be changed
automatically.
- In case of the FUJIFILM-made AP, the "WSTAT" LED flashes red during the
DFS search operation.
- When selecting 2.4 GHz on the FUJIFILM-made AP, select 20 MHz on the "Channel
Width". Do not select 40 MHz.
DR-ID 1300 / DR-ID 1300PU Service Manual
MU2-61
MU2-61