FujiFilm DR-ID 1300 Service Manual page 451

NOTE
- Select the folder corresponding with the IMAGE READING MODE settings in
RU Image Flag.
{MU1:1.3.2_RU Image Flag}
- The folders suitable for IMAGE READING MODE are stored in the folders by
the serial ID of the panel unit in the root of the machine-specific data CD-ROM.
Select the folder in the serial ID of the panel unit corresponding to the panel
number.
CD-ROM
└<Serial ID for TOP panel unit> (TOP) folder
└CORRECTH folder
└CORRECTS folder
└<Serial ID for CENTER panel unit> (CENTER) folder
└CORRECTH folder
└CORRECTS folder
└<Serial ID for BOTTOM panel unit> (BOTTOM) folder
└CORRECTH folder
└CORRECTS folder
REFERENCE
Select the "CORRECTH" folder nomally.
However, if in the acceptance check the noise was generated in the image
whereas physical phantoms such as mesh, etc. are used to expose, select the
"CORRECTS" folder. For the procedure for changing the folder selection, refer to
"l IMAGE READING MODE" of "MU1:1.3.2_RU Image Flag".
{MU1:1.3.2_RU Image Flag}
018-234-06E
(4) Click [OK].
The Machine-Specific Data has been installed.
NOTE
In case of installing the machine-specific data failed, restart the SE and execute
from SE connection confirmation again.
(5) For forced transfer of SE correct data, then click [OK].
SE correct data is forcibly transferred.
NOTE
In case of correct data forced transfer failed, restart the SE and execute from SE
connection confirmation again.
(6) Click [OK].
(7) Repeat (2) to (6) for the remaining two panel units.
DR-ID 1300 / DR-ID 1300PU Service Manual
1200_700515E.ai
1200_700516E.ai
1200_700517E.ai
IN1-70
IN1-70