FujiFilm DR-ID 1300 Service Manual page 82

Bit Detailed code Detailed error name
X-ray detection before ready
18 0x00040000
User operation error.
19 0x00080000 Panel cracking judgment
20 0x00100000 DDR2 error
21 0x00200000 Config error
22 0x00400000 PPC access error
23 0x00800000 Electrical noise detection
24 0x01000000 Thermistor error
25 0x02000000 Undefined
26 0x04000000 Long panel error
27 0x08000000 IP address jig error
28 0x10000000 Gate IC error
29 0x20000000 Serial ID registration error
30 0x40000000 Image processing error
31 0x80000000 Exposure sequence error
32 0x10080000 Gate IC/Panel cracking judgment
018-234-06E
Escalation is not required
If the image is white, replace the GLG board, POW board, and RMV board.
Otherwise, disconnect and insert the cables connected to the RMV board, POW board, and GLG board.
If it does not improve, replace the SE.
Replace the RMV board.
Replace the RMV board.
Replace the RMV board.
Occurring due to static electricity, etc.
If this occurs frequently, then an on-site investigation which includes the facility environment and users, etc. needs to be conducted.
"Error code: 13043 Electrical noise detected" is displayed on the CSL.
Restart.
There is a high probability that this is occurring due to static electricity, etc.
If this occurs frequently, then an on-site investigation which includes the facility environment and users, etc. needs to be conducted.
Check the RMV board's connect connection condition.
Also check that the panel ID settings are correct.
Replace the RMV board and SE connector.
For the DR-ID1214SE (the initial letter of panel ID is Y), and DR-ID1213SE (the initial letter of panel ID is W), also replace the BCN
board.
Replace the RMV board and POW board.
If it does not improve, replace the SE.
Error occurs via the SE's FPGA.
Upgrade or downgrade the SE's FPGA.
Replace the RMV board.
Replace the RMV board.
Replace the GLG board, POW board and RMV board.
If it does not improve, replace the SE.
DR-ID 1300 / DR-ID 1300PU Service Manual
Countermeasure
MT-5
MT-5