FujiFilm DR-ID 1300 Service Manual page 583

n Enabling the set value
Enable the network address input in the Local Network PreSetting>> window.
CAUTION
Enable the set value in the order of the SE, MP and MC to make them effective.
If a wrong order is taken, the setting does not get effective, and might result in
need of initializing the machine.
<Enabling the set value (SE)>
INSTRUCTION
u u
Connect only one SE when enabling the set value (SE). Otherwise, the SE whose IP
address is changed cannot be identified, and might result in need of initializing the SE.
(1) Click [SE Network Setting >>] on the NETWORK SETTING window.
The SE Network Setting >> window appears.
(2) Input the target SE No. and click [SET].
(3) Click [Execute SE IP Setting].
The confirmation dialogue box of "Are you sure?" appears.
(4) Click [OK].
018-234-02E
(5) Check that the set value is effective.
The IP addresses of the SE and the MC are rewritten, and the IP addresses are
reflected after restarting the SE and the MC.
u NOTE u
Restart only the SE in this procedure.
#1 Check: OK indication
SE Network Setting>>window <Display example>
(6) Click [BACK] to return to the NETWORK SETTING window.
(7) Disconnect the SE cable from the SE.
(8) If an unspecified SE exists, repeat procedures (1) to (7).
(9) Connect the SE cable to the specified SE.
DR-ID 1300 / DR-ID 1300PU Service Manual
AppxIN3-3
#1
1200_700167E.ai
AppxIN3-3