FujiFilm DR-ID 1300 Service Manual page 622

n Installing FPGA software by using the jig software
l Preparations
If the FPGA needs to be installed by the jig software as a result of the "■ Confirm the
resolution details", install the FPGA software as per the following procedures.
NOTE
When replacing the board with the new FPGA memory equipped service part, perform
the board replacement procedure up to the step for "inputting the SE serial ID" as
usual.
{MC:3.1.3_RMV65A Board}
(1) Prepare jig software.
Decompress FlashUpdate.zip and copy the "FPGAUpdate" folder to the desktop.
(2) Make sure that the MC Manager has not started up.
(3) Connect the SE cable to the target SE.
018-234-06E
l Install via the jig software
(1) Double-click on the jig software execution file FlashUpdate.exe.
NOTE
When the above file is executed, the firewall block message may appear. Place a
checkmark to "Permission" and click [Allow access].
The startup window appears.
(2) When the SE's IP address is the default (192.168.0.30), the jig software
is automatically connected to the panel and the next window appears.
NOTE
If the SE's IP address is not the default, select "IP Address" from "Setting".
In the "IP Address Setting" window, enter the SE's IP address and click [Close].
When the jig software is connected to the SE, the next window automatically
appears.
DR-ID 1300 / DR-ID 1300PU Service Manual
1300_70J001.ai
1300_70J002.ai
1300_70J003.ai
AppxIN9-2
AppxIN9-2