FujiFilm DR-ID 1300 Service Manual page 189

 Setting Items
 SE SLEEP MODE
Set the SE sleep mode.
<Options>
- OFF: Disable the power save mode.
- ON [default]: Enable the power save mode.
 SLEEP START TIME (min)
Set the time in minutes units until when the power save mode is started.
<Setting range>
- 2 to 10 [default: 2]
REFERENCE
Shift to the sleep mode mainly in the following cases.
- After completing the initialization calibration
- After completing the exposure
- After cancelling the exposure
- After switching the panel by changing the selector for the DX Console
- After completing the automatic offset update
- After completing the periodical defect calibration
- After completing the automatic log update
 EXTRA SLEEP START TIME (min)
Set the time in minutes units until when the extra sleep mode is started.
<Setting range>
- 2 to 999 [default: 999]
REFERENCE
- After all the SEs shift to the sleep mode and past the set time by this setting, shift to
the extra sleep mode.
- When set to "999", do not shift to the extra sleep mode.
018-234-06E DR-ID 1300 / DR-ID 1300PU Service Manual
MU1-24
MU1-24