FujiFilm DR-ID 1300 Service Manual page 628

5. Checking for image problems
{IN1:13._Checking for Image Problems}
{IN2:13._Checking for Image Problems}
 Check for image nonuniformity
 Check for white blank portion
5.1 Calibration
- TOP SE panel
X-ray dose: ______mR S value: _____
Tube current: ______mA Time: _____msec
- CENTER SE panel
X-ray dose: ______mR S value: _____
Tube current: ______mA Time: _____msec
- BOTTOM SE panel
X-ray dose: ______mR S value: _____
Tube current: ______mA Time: _____msec
5.2 Additional filter
 Yes (If Yes, AL: ____mm, Cu: ____mm)  No
6. Backing up the machine-specific data
{IN1:16._Backing Up the Data}
{IN2:16._Backing Up the Data}
7. Keep output films as the record of performance check
8. Test equipment used for the check
Test equipment: ____________
Test equipment: ____________
Test equipment: ____________
018-234-04E
 OK  NG
 OK  NG
 OK  NG
Tube voltage: _____kV
Distance: _____cm
Tube voltage: _____kV
Distance: _____cm
Tube voltage: _____kV
Distance: _____cm
 OK  NG
 OK  NG
 OK  NG
Model: ____________ S/N: ____________
Model: ____________ S/N: ____________
Model: ____________ S/N: ____________
DR-ID 1300 / DR-ID 1300PU Service Manual
PC-3
PC-3