FujiFilm DR-ID 1300 Service Manual page 444

(8) Select "CONFIG - NETWORK CONFIG - ALL OTHER NODES" and click
[NEW].
The New Node window opens.
#1 Select: ALL OTHER NODES
#2 Click: [NEW]
Setup Configuration Item window
#1
#2
1200_700140.ai
(9) Make the following settings and click [OK].
NOTE
The IP address to be entered in "IP Address" depends on the installation
destination of the MC application.
- To install in the DX Console: 127.0.0.1
#1 Input: HostName and IP Address (127.0.0.1)
#2 Select: CU/MC
#3 Click: [OK]
New Node window
#1
018-234-05E
#3
#2
1200_700144.ai
NOTE
Depending on the SE registration count, set the image folder sizes.
As needed, click "SYSTEM CONFIG" – "99.CONFIG FIX" via the IIP Service Utility
window – [Setup Configuration Item], and set the "MaximumDataSize" values. If the
setting values are incorrect, then the "[MD10016] hard disc is full." error might be
displayed.
For details, see "21. Setting the Images Folder Size (V7.3 or later)" in "MC:
Checks, Replacement and Adjustment of Parts"under "DR-ID 300CL Service
Manual".
(10) Restart the DR Maintenance Software.
REFERENCES
To restart the DR Maintenance Software, once close and reopen Internet Explorer.
(11) Click [Next] on the DR Maintenance Software.
(12) Click [Next] in the "Setting the Serial ID of the SE" window.
NOTE
With the DR-ID 1300, set the SE serial ID via the "Setting the Serial ID of the GL
Panel". Therefore, do not enter anything in the "Setting the Serial ID of the SE".
DR-ID 1300 / DR-ID 1300PU Service Manual
IN1-63
1200_700496E.ai
1200_700497E.ai
IN1-63