FujiFilm DR-ID 1300 Service Manual page 222

 Changing the MP's IP addresses (MP2 settings)
If two MPs are going to be connected, change and set MP1 as MP2.
(1) Turn OFF the power of the first MP.
(2) Turn ON the power of the second MP.
(3) Click "NETWORK SETTING" - "MP Network Setting".
The MP Network Setting window opens.
(4) Select "MP1" from the drop-down list box, and click [Re-acquire
connected MP].
(5) Select "Setting for MP2", and click [SET].
The MP2 IP address which was input via "Changing the MP's IP addresses
(presets)" will be enabled, and at the same time MP1 will be set as MP2.
(6) Turn OFF the power of the MP, and then turn it ON again.
018-234-06E
(3)
(4)
(4)
(5)
1200_400170E.ai
DR-ID 1300 / DR-ID 1300PU Service Manual
(7) Left-click the MC Manager from the task tray and execute "EXIT".
Check that the MC Manager icon has disappeared from the task tray,
and then start the MC Manager from "Start menu" → "Start-up".
REFERENCE
The relationship between the target MP and "Select MP whose destination is to
be changed." radio button is mentioned below.
● Target MP: MP1
- Setting for MP1
Set the IP address of the MP1 as the MP1 value input in "Changing the MP IP
Address (Preset)".
- Setting for MP2
Change the setting of the MP1 to the MP2.
The MP2 value input in "Changing the MP IP Address (Preset)" gets effective.
● Target MP: MP2
- Setting for MP1
Change the MP set as the MP2 to the MP1.
Not in use usually.
- Setting for MP2
Change the IP address of the MP2.
Set the IP address of the MP2 to the MP2 value input in "Changing the MP IP
Address (Preset)".
MU1-57
MU1-57