FujiFilm DR-ID 1300 Service Manual page 195

 Lag Calibration
Carries out lag calibration.
- Exposure count: 1
018-234-06E
(1)
(2)
1200_400072E.ai
DR-ID 1300 / DR-ID 1300PU Service Manual
(1) Select the target operative method from the drop-down list box.
(2) Click [START].
u NOTE u
Clicking [START] during automatic offset update (approximately 30 seconds
every 10 minutes), "Error 12700 currently unavailable" is displayed. Again click
[START] approx. 30 seconds later in this case.
REFERENCE
Whether the calibration is successfully completed appears after completion.
An error code is displayed in some cases. Refer to the Troubleshooting manual
and take appropriate countermeasures.
After about 2 minutes, the [Ready] button will be displayed in green in the pop up
window.
u NOTE u
If you perform exposure before [Ready] is lit up with the green button, calibration
will fail and create an abnormal image.
(3) Expose 1 time with the following condition.
1305SE: Tube voltage of 80 kV, dose of 100 mR
Images for lag correction data generation (7 frames) are read from the SE (FPD).
Images of seven frames are read with a predetermined interval for one exposure.
The number of image reads is displayed in the format of "n/7".
u INSTRUCTION u
Set the exposure time to 200 msec or less. Exposure for longer than 200 msec
cannot be made, since the maximum exposure time is inherently specified as
200 msec.
MU1-30
MU1-30