FujiFilm DR-ID 1300 Service Manual page 414

(4) Insert the second X-Ray shot cable (optional) and the bucky cable
from the MP rear, and connect the cable terminals with the terminal
blocks (TB1 and TB2) of the AC bucky relay unit.
WARNING
Be sure to connect the X-Ray shot cable and the FG line of the bucky cable to
the FG (TB2-6) of the terminal block. If the FG line is fixed to the MP frame or the
like, electrification or ignition might result due to difference in ground levels.
u NOTE u
If the second X-Ray shot cable and the second bucky cable are not present, the
procedure is not necessary. Proceed to the procedure (5).
u NOTE u
The terminals to be connected with the second X-Ray shot cable and the second
bucky cable are indicated in white cells in the table below.
No. TB1
X-Ray shot cable Bucky cable
1 X-Con BKY SHOT1 RDY1 (L)
2 X-Con BKY SHOT1 RDY1 (N)
3 X-Con SHOT1 RDY2 (L)
4 X-Con BKY SHOT1 RDY2 (N)
5
BKY SHOT1 RDY2 (L)
6 X-Con BKY SHOT2 RDY1 (L)
7 X-Con BKY SHOT2 RDY1 (N)
8 X-Con SHOT2 RDY2 (L)
9 X-Con BKY SHOT2 RDY2 (N)
10 BKY SHOT2 RDY2 (L)
018-234-04E
TB2
X-Ray shot cable Bucky cable
X-Con BKY Stand AC (L)
X-Con BKY Stand AC (N)
X-Con BKY Bed AC (L)
X-Con BKY Bed AC (N)
N.C. N.C.
X-Con BKY Stand FG
X-Con BKY Bed FG
X-Con BKY Stand Exp A
X-Con BKY Stand Exp B
X-Con BKY Bed Exp A
X-Con BKY Bed Exp B
TB1
1
2
3
4
5
6
7
8
9
10
DR-ID 1300 / DR-ID 1300PU Service Manual
X-Ray shot cable
Bucky cable
TB2
1
2
3
4
5
6
7
8
9
10
Bucky cable
X-Ray shot cable
IN1-33
600_700051.ai
IN1-33