FujiFilm DR-ID 1300 Service Manual page 162

(5) Install the new HUB.
NOTE
Install the HUB at the position where it is applied to the two spacers installed in
step (3).
Apply the HUB
1300_3B0003-01.ai
018-234-06E
(6) Install the LAN cable and the power cable to the new HUB.
NOTE
- Connect the LAN cable to the HUB in the order of HUB5 to HUB1.
After that, insert the DC jack (new cable) into the power outlet.
- Use the LED ON/OFF switch with the switch popped out.
OK
LED ON/OFF switch: popped out
(7) Install the rear cover.
NOTE
For the HUB mounting part, use the rear cover HUB mounting part spacer the
same way as for the old HUB.
(8) After the installation is completed, confirm that it operates normally.
DR-ID 1300 / DR-ID 1300PU Service Manual
AppxMC2-2
NG
LED ON/OFF switch: retracted
1300_3B0003.ai
(6)
(5)
1300_3B0004.ai
AppxMC2-2