FujiFilm DR-ID 1300 Service Manual page 434

l Setup the MC application
(1) Double-click "SetupRun.exe" into the drive on the My Computer.
The "Set Up PC-TOOL" window appear.
(2) Select ".\install\remote\MCSetupWizard.bat" from "FILE EXECUTION"
area, and click [EXECUTE].
#1 Select: .\install\remote\MCSetupWizard.bat
#2 Click: [EXECUTE]
Set Up PC-TOOL window
1200_700428.ai
(3) Input the target MC IP address and click [Connect].
#1 Input: MC IP address (for MC-less configuration "127.0.0.1")
#2 Click: [Connect]
018-234-04E
#1
#2
#1
#2
1200_700429.ai
u NOTE u
- If the MC could not be connected to due to the mistaken inputting of the IP
address, a connection error occurs. After checking the connection status, re-
execute the version upgrade.
- If the MC application was not factory-installed, and if the model media being
used differs from the model which was installed, then the error will appear.
Confirm the MC application installation status and the media model information,
and re-execute the version upgrade.
u INSTRUCTION u
If the RU registration has been already completed, steps 4 and 5 are not
necessary. Proceed to step 6.
(4) If the RU registration has not been completed, the following window
opens. Click [OK].
#1 Click: [OK]
1200_700431.ai
(5) Input the RU NAMEand click [Register].
#1 Input: RU NAME
#2 Click: [Register]
The version and the media version that are installed on the device appear.
DR-ID 1300 / DR-ID 1300PU Service Manual
1200_700430.ai
#1
#1
#2
1200_700432.ai
IN1-53
IN1-53