FujiFilm DR-ID 1300 Service Manual page 93

Error
Error Name
Code
Unexpected notification of
12405
exposure performance
Exposure performance out of
12406
range
12407 Serial communication error
12500 Invalid exposure parameters
12501 Invalid application mode
12502 Line disconnection detected
12503 Invalid message from CL
12504 CL response error
12599 CL system error
018-234-06E
Occurrence Condition
[During routine processing]
The exposure performance is notified although the exposure conditions
are not notified.
The exposure performance notified from the retro radiation source is out
of the range defined by the CU.
The following error occurs in the serial communication with the retro
irradiation source.
[During routine processing]
Exposure condition parameters sent from the CL are unrecognizable
values.
<Reference>
You can know the unrecognizable items and values on the error log.
[During routine processing]
An application mode which cannot be supported by the system controller
of the CU is sent from the CL.
<Reference>
- An application mode refers to a mode of exposures such as normal
still image exposure, long cassette exposure, tomography and energy
subtraction.
- The unsupportable mode application mode means such conditions
that an erroneous mode is set against the operative method, such as
tomography in the chest position or long cassette exposure in the bed
position.
- You can know the application mode and the operative method on the
error log.
[During routine processing]
Breakage of the line with the CL is detected.
(Except when the line is intentionally cut for termination or utility)
[During routine processing]
An unrecognizable message is received during communication with the
CL.
<Reference>
You can know the command name which is received but cannot be
recognized on the error log.
[During bootup/routine processing]
Response other than normal is received from the CL.
[During bootup/routine processing]
An error is detected in the CL system.
DR-ID 1300 / DR-ID 1300PU Service Manual
Probable Cause and Remedy
- Check the CL exposure conditions.
- Check the CL exposure conditions.
- Check the LAN cable.
- Check the CL software version.
- Check the CU software version.
MT-16
MT-16