Display Auto-Tune Attributes - 3Com Wireless LAN Switch WX1200 Command Reference Manual

display auto-tune
attributes
Table 57 Output for display ap status terse and display dap status terse
Field
Port
Flg
IP Address
Model
MAC Address
Radio1
Radio2
Uptime
Displays the current values of the RF attributes RF Auto-Tuning uses to
decide whether to change channel or power settings.
Syntax —

display auto-tune attributes

[ap map-num [radio {1 | 2 | all}]]
Syntax — display auto-tune attributes
[dap dap-num [radio {1 | 2 | all}]]
map-num — MAP port connected to the MAP access point for which to
display RF attributes.
dap-num — Number of a Distributed MAP for which to display RF
attributes.
radio 1 — Shows RF attribute information for radio 1.
radio 2 — Shows RF attribute information for radio 2. (This option
does not apply to single-radio models.)
radio all — Shows RF attribute information for both radios.
Defaults — None.
Description
WX port number connected to the MAP.
Operational status flags for the MAP.
For flag definitions, see the key in the command output.
IP address of the MAP. The address is assigned to the MAP by
a DHCP server.
This field is applicable only if the MAP is configured on the
WX switch as a Distributed MAP.
MAP model number.
MAC address of the MAP.
State, channel, and power information for radio 1:
The state can be D (disabled) or E (enabled).
The channel and power settings are shown as
channel/power.
State, channel, and power information for radio 2.
Amount of time since the MAP booted using this link.
display auto-tune attributes 309