Set {Ap | Dap} Name - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set {ap | dap} name

If you use the name none, spelled in any combination of capital or
lowercase letters, the specified MAP access point is cleared from all MAP
access point groups.
Examples — The following command configures a MAP access point
group named loadbalance1 that contains the MAP access points on ports
1, 3, and 5:
WX1200# set ap 1,3,5 group loadbalance1
success: change accepted.
The following command removes the MAP access point on port 4 from all
MAP access point groups:
WX1200# set ap 4 group none
success: change accepted.
See Also
display {ap | dap} config on page 290
display {ap | dap} group on page 303
Changes a MAP name.
Syntax — set {ap port-list | dap dap-num} name name
ap port-list — List of ports connected to the MAP access point to
rename.
dap dap-num — Number of a Distributed MAP to rename.
name — Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is MAP01. The default
name of a Distributed MAP is based on the number you assign to it when
you configure the connection. For example, the default name for
Distributed MAP 1 is DAP01.
Access — Enabled.
History —Introduced in MSS Version 3.0. Default Distributed MAP name
changed from DMPnum to DAPnum in MSS Version 4.1.
set {ap | dap} name 333