Set Service-Profile Wep Key-Index - 3Com Wireless LAN Switch WX1200 Command Reference Manual

390 C 11: M
HAPTER
set service-profile
wep key-index
A P C
ANAGED CCESS OINT OMMANDS
Sets the value of one of four static Wired-Equivalent Privacy (WEP) keys
for static WEP encryption.
Syntax —
set service-profile name wep key-index num key value
— Service profile name.
name
key-index num
through 4.
key value
10-character ASCII string representing a 5-digit hexadecimal number
or a 26-character ASCII string representing a 13-digit hexadecimal
number. You can use numbers or letters. ASCII characters in the
following ranges are supported:
0 to 9
A to F
a to f
Defaults — By default, no static WEP keys are defined.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — MSS automatically enables static WEP when you define a WEP
key. MSS continues to support dynamic WEP.
If you plan to use static WEP, do not map more than 8 service profiles
that contain static WEP keys to the same radio profile.
Examples — The following command configures WEP key index 1 for
service profile sp2 to aabbccddee:
WX4400# set service-profile sp2 wep key-index 1 key
aabbccddee
success: change accepted.
See Also
set service-profile wep active-multicast- index on page 388
set service-profile wep active-unicast- index on page 389
— WEP key index. You can enter a value from 1
— Hexadecimal value of the key. You can enter a