3Com Wireless LAN Switch WX1200 Command Reference Manual page 462

462 C 14: S
HAPTER ECURITY
ACL C
OMMANDS
(For a complete list of TCP and UDP port numbers, see
www.iana.org/assignments/port-numbers.)
destination-ip-addr mask
network or host to which the packet is being sent. Specify both
address and mask in dotted decimal notation. For more information,
see "Wildcard Masks" on page 26.
type icmp-type
from 0 through 255. (For a list of ICMP message type and code
numbers, see www.iana.org/assignments/icmp-parameters.)
code icmp-code
filters ICMP messages by code. Specify a value from 0 through 255.
(For a list of ICMP message type and code numbers, see
www.iana.org/assignments/icmp-parameters.)
precedence precedence
Specify a value from 0 through 7:
— routine precedence
0
— priority precedence
1
2 — immediate precedence
— flash precedence
3
— flash override precedence
4
— critical precedence
5
— internetwork control precedence
6
7 — network control precedence
— Filters packets by type of service (TOS) level. Specify one of
tos tos
the following values, or any sum of these values up to 15. For
example, a tos value of 9 filters packets with the TOS levels minimum
delay (8) and minimum monetary cost (1).
— minimum delay
8
4 — maximum throughput
2 — maximum reliability
— minimum monetary cost
1
— normal
0
— For TCP packets only, applies the ACE only to
established
established TCP sessions and not to new TCP sessions.
— IP address and wildcard mask of the
— Filters ICMP messages by type. Specify a value
— For ICMP messages filtered by type, additionally
— Filters packets by precedence level.