Set Radius Server - 3Com Wireless LAN Switch WX1200 Command Reference Manual

494 C 16: RADIUS
HAPTER

set radius server

S G C
AND ERVER ROUP OMMANDS
Examples — The following command maps SSID mycorp to packets
received on port 3 or 4, using 802.1Q tag value 104:
WX4400# set radius proxy port 3-4 tag 104 ssid mycorp
success: change accepted.
See Also
clear radius proxy port on page 488
set authentication proxy on page 241
set radius proxy client on page 492
Configures RADIUS servers and their parameters. By default, the WX
switch automatically sets all these values except the password (key).
Syntax — set radius server
[address ip-address] [auth-port port-number] [acct-port
port-number] [timeout seconds] [retransmit number] [deadtime
minutes] [key string] [author-password password]
server-name — Unique name for this RADIUS server. Enter an
alphanumeric string of up to 32 characters, with no blanks.
address ip-address
address in dotted decimal notation.
auth-port port-number
authentication and authorization.
acct-port port-numbe
accounting.
timeout seconds
RADIUS server to respond before retransmitting. You can specify from
1 to 65,535 seconds.
retransmit number
before declaring an unresponsive RADIUS server unavailable. You can
specify from 1 to 100 retries.
deadtime minutes
declaring an unresponsive RADIUS server unavailable before retrying
that RADIUS server. Specify between 0 (zero) and 1440 minutes
(24 hours). A zero value causes the switch to identify unresponsive
servers as available.
server-name
— IP address of the RADIUS server. Enter the
— UDP port that the WX switch uses for
r — UDP port that the WX switch uses for
— Number of seconds the WX switch waits for the
— Number of transmission attempts made
— Number of minutes the WX switch waits after