Set Ip Ssh - 3Com Wireless LAN Switch WX1200 Command Reference Manual

170 C 7: IP S
HAPTER

set ip ssh

C
ERVICES OMMANDS
History — Introduced in MSS Version 3.0.
Examples — The following command enables the SNMP server on a WX switch:
WX4400# set ip snmp server enable
success: change accepted.
See Also
set port trap on page 90
set snmp community on page 175
Changes the TCP port number on which a wireless LAN switch listens for
Secure Shell (SSH) management traffic.
CAUTION: If you change the SSH port number from an SSH session, MSS
immediately ends the session. To open a new management session, you
must configure the SSH client to use the new TCP port number.
Syntax — set ip ssh port port-num
port-num
Defaults — The default SSH port number is 22.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the SSH port number on
a WX switch to 6000:
WX4400# set ip ssh port 6000
success: change accepted.
See Also
set ip ssh server on page 171
— TCP port number.