Commands By Usage - 3Com Wireless LAN Switch WX1200 Command Reference Manual

2 2
22
Commands by
Usage
S C
NOOP OMMANDS
Use snoop commands to monitor wireless traffic, by using a Distributed
MAP as a sniffing device. The MAP copies the sniffed 802.11 packets and
sends the copies to an observer, which is typically a protocol analyzer
such as Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring
station, see the "Remotely Monitoring Traffic" section in the
"Troubleshooting a WX Switch" chapter of the
Controller Configuration
This chapter presents snoop commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 108 Remote Monitoring (Snooping) Commands By Usage
Remote
monitoring
(snooping)
Guide.)
set snoop on page 599
display snoop info on page 604
clear snoop on page 598
set snoop map on page 602
display snoop map on page 605
display snoop on page 604
clear snoop map on page 598
set snoop mode on page 603
display snoop stats on page 606
Wireless LAN Switch and