Set Rfdetect Vendor-List - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set rfdetect
vendor-list
Defaults — The permitted SSID list is empty by default and all SSIDs are
allowed. However, after you add an entry to the list, MSS allows traffic
only for the SSIDs that are on the list.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The permitted SSID list applies only to the WX switch on which
the list is configured. WX switches do not share permitted SSID lists.
If you add a device that MSS has classified as a rogue to the permitted
SSID list, but not to the ignore list, MSS can still classify the device as a
rogue. Adding an entry to the permitted SSID list merely indicates that
the device is using an allowed SSID. However, to cause MSS to stop
classifying the device as a rogue, you must add the device's MAC address
to the ignore list.
Examples — The following command adds SSID mycorp to the list of
permitted SSIDs:
WX1200# set rfdetect ssid-list mycorp
success: ssid mycorp is now in ssid-list.
See Also
clear rfdetect ssid-list on page 536
display rfdetect ssid-list on page 550
Adds an entry to the permitted vendor list. The permitted vendor list
specifies the third-party AP or client vendors that are allowed on the
network. MSS does not list a device as a rogue or interfering device if the
device's OUI is in the permitted vendor list.
Syntax — set rfdetect vendor-list {client | ap} mac-addr
client | ap — Specifies whether the entry is for an AP brand or a
client brand.
— Organizationally Unique Identifier (OUI) to remove.
mac-addr

set rfdetect vendor-list

561