3Com Wireless LAN Switch WX1200 Command Reference Manual page 93

Table 18 MAP Access Port Defaults
Port Parameter
VLAN membership
Spanning Tree Protocol
(STP)
802.1X
Port groups
IGMP snooping
Maximum user
sessions
This command does not apply to any gigabit Ethernet ports or to ports 7
and 8 on the WX1200 switch. To manage a MAP access point on a
switch model that does not have 10/100 Ethernet ports, use the set dap
command to configure a Distributed MAP connection on the switch.
Examples — The following command sets ports 1 through 3 and port 5
for MAP access point model AP2750 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap2750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP7250 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap7250 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP8250 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap8250 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
The following command sets ports 1 through 3 and port 5 for MAP
access point model AP8750 and enables PoE on the ports:
WX1200# set port type ap 1-3,5 model ap8750 poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
Setting
Removed from all VLANs. You cannot assign a MAP access
port to a VLAN. MSS automatically assigns MAP access
ports to VLANs based on user traffic.
Not applicable
Uses authentication parameters configured for users.
Not applicable
Enabled as users are authenticated and join VLANs.
Not applicable
set port type ap 93