Set Radius Proxy Client - 3Com Wireless LAN Switch WX1200 Command Reference Manual

492 C 16: RADIUS
HAPTER
set radius proxy
client
S G C
AND ERVER ROUP OMMANDS
Usage — The WX system IP address must be set before you use this
command.
Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
clear radius client system-ip on page 487
set system idle-timeout on page 58
Adds a RADIUS proxy entry for a third-party AP. The proxy entry specifies
the IP address of the AP and the UDP ports on which the WX switch
listens for RADIUS traffic from the AP.
Syntax — set radius proxy client address ip-address
[acct-port acct-udp-port-number] [port udp-port-number] key
string
address ip-address
address in dotted decimal notation.
port udp-port-number
for RADIUS access-requests from the AP.
acct-port acct-udp-port-number
switch listens for RADIUS stop-accounting records from the AP.
key string — Password (shared secret key) the WX switch uses to
authenticate and encrypt RADIUS communication.
Defaults — The default UDP port number for access-requests is 1812.
The default UDP port number for stop-accounting records is 1813.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — AAA for third-party AP users has additional configuration
requirements. See the "Configuring AAA for Users of Third-Party APs"
section in the "Configuring AAA for Network Users" chapter of the
Wireless LAN Switch and Controller Configuration
— IP address of the third-party AP. Enter the
— UDP port on which the WX switch listens
— UDP port on which the WX
Guide.