Set Dap Auto Mode - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set dap auto mode

11a — 802.11a
11b — 802.11b
11g — 802.11g
Defaults — The default radio type for models AP2750, MP-241, and
MP-341, and for the 802.11b/g radios in other models is 802.11g in
regulatory domains that support 802.11g, or 802.11b in regulatory
domains that do not support 802.11g.
MAP radios configured for 802.11g also allow associations from 802.11b
clients by default. To disable support for 802.11b associations, use the
set radio-profile 11g-only command on the radio profile that contains
the radio.
Examples — The following command sets the radio type to 802.11b:
WX4400# set dap auto radiotype 11b
success: change accepted.
See Also
set dap auto on page 325
Enables a WX switch's profile for automatic Distributed MAP
configuration.
Syntax — set dap auto mode {enable | disable}
enable — Enables the MAP configuration profile.
disable — Disables the MAP configuration profile.
Defaults — The MAP configuration profile is disabled by default.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — You must use the set dap auto command to create the profile
before you can enable it.
set dap auto mode 327