Set Service-Profile Shared-Key-Auth; Set Service-Profile Ssid-Name - 3Com Wireless LAN Switch WX1200 Command Reference Manual

384 C 11: M
HAPTER
set service-profile
shared-key-auth
set service-profile
ssid-name
A P C
ANAGED CCESS OINT OMMANDS
Enables shared-key authentication, in a service profile.
Use this command only if advised to do so by 3Com. This command does
not enable preshared key (PSK) authentication for Wi-Fi Protected Access
(WPA). To enable PSK encryption for WPA, use the
set service-profile auth-psk command.
Syntax —
set service-profile name shared-key-auth {enable |
disable}
— Service profile name.
name
— Enables shared-key authentication.
enable
disable — Disables shared-key authentication.
Defaults — Shared-key authentication is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command enables shared-key authentication
in service profile sp4:
WX4400# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also
display radio-profile on page 317
set radio-profile mode on page 362
Configures the SSID name in a service profile.
Syntax —
set service-profile name ssid-name ssid-name
— Service profile name.
name
ssid-name
include blank spaces in the name, if you delimit the name with single
or double quotation marks. You must use the same type of quotation
mark (either single or double) on both ends of the string.
Defaults — The default SSID name is private.
— Name of up to 32 alphanumeric characters. You can